Cross Back Straps Black Backless Corset Top

“cross back straps black backless corset top” translates roughly to "backless dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production this is a corset bodice backless dress, cut in black. A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

A corset bodice is a build: boning channels, a waist tape to take the strain, and a busk or a lace-up back. The bones have to stop below the bust line or the top edge will curl out. Black shows every loose thread and every dust mark on the fitting table, so the final inspection has to include a lint pass.

What Has To Be Specified

• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Detail: Corset Bodice. A corset bodice is a build: boning channels, a waist tape to take the strain, and a busk or a lace-up back. The bones have to stop below the bust line or the top edge will curl out.
• Colour: Black, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

A corset bodice is a build: boning channels, a waist tape to take the strain, and a busk or a lace-up back. The bones have to stop below the bust line or the top edge will curl out.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Detail alternatives on the Corset Bodice: scaled up, reduced to a plain panel, or moved to the back for a cleaner front.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Packing: flat-fold with tissue, hanger-ready, or individual sealed bag for glitter and bead styles.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.