Transitional Velvet Split Sleeve Blazer

When a request arrives with “transitional velvet split sleeve blazer” in it, the useful first question is not the price. It is which of these attributes the buyer actually intends to sell on.

In production this is a velvet long sleeves blazer. Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board. A sheath blazer is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Long sleeves mean the cuff, the sleeve length and the armhole all have to be agreed - and on a beaded fabric the sleeve seam has to be taped so it does not pull.

What Has To Be Specified

• Shell: Velvet, hand and weight approved on a physical swatch - imported cloth rarely matches a screen.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Detail: Long Sleeves. Long sleeves mean the cuff, the sleeve length and the armhole all have to be agreed - and on a beaded fabric the sleeve seam has to be taped so it does not pull.
• Colour: name the exact tone and send a swatch. In this category a photo is not a colour reference.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board.

A sheath blazer is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Long sleeves mean the cuff, the sleeve length and the armhole all have to be agreed - and on a beaded fabric the sleeve seam has to be taped so it does not pull.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Options We Can Build To

• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Detail alternatives on the Long Sleeves: scaled up, reduced to a plain panel, or moved to the back for a cleaner front.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.