Wholesale Black Backless Slip Dress

When a request arrives with “wholesale black backless slip dress” in it, the useful first question is not the price. It is which of these attributes the buyer actually intends to sell on.

In production this is a backless dress, cut in black. A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Black shows every loose thread and every dust mark on the fitting table, so the final inspection has to include a lint pass.

What Has To Be Specified

• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: Black, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Beading is quoted per panel and bought per gram. A 15% allowance sounds generous until the third size run lands.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.