Women's White Cross Back Straps Backless Satin Dress

“women's white cross back straps backless satin dress” translates roughly to "satin backless dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production this is a satin backless dress, cut in white. Satin shows every needle mark and every bubble at the seam. Use a fine needle, a soft press cloth, and hang the dress for 24 hours before the final measurement. A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

White backless dresses sit close to bridal, so specify the exact white (optical, ivory, cream) and warn the buyer about optical brighteners.

What Has To Be Specified

• Shell: Satin, hand and weight approved on a physical swatch - imported cloth rarely matches a screen.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: White, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Satin shows every needle mark and every bubble at the seam. Use a fine needle, a soft press cloth, and hang the dress for 24 hours before the final measurement.

A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Options We Can Build To

• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.