Women's Deep Low Back Backless Silk Dress

When a request arrives with “women's deep low back backless silk dress” in it, the useful first question is not the price. It is which of these attributes the buyer actually intends to sell on.

In production this is a silk backless dress. Silk gives the drape and the sheen, and it brings the QC problems with it: it water-spots, it slips under the needle, and it needs a cool press. A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

What Has To Be Specified

• Shell: Silk, hand and weight approved on a physical swatch - imported cloth rarely matches a screen.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: name the exact tone and send a swatch. In this category a photo is not a colour reference.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Silk gives the drape and the sheen, and it brings the QC problems with it: it water-spots, it slips under the needle, and it needs a cool press.

A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.
• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.