Women's Lace Up Back Backless Maxi Dress

“women's lace up back backless maxi dress” translates roughly to "long lace backless dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production this is a long lace backless dress. A long backless dress runs to the ankle or the floor, which makes sweep and hem finish the design. A floor-length hem needs a horsehair or a weighted tape, or it will collapse in wear. Lace is judged on the ground rather than the pattern: corded lace holds a bodice, soft French lace drapes, and the scalloped edge dictates where the hem can actually finish. A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

What Has To Be Specified

• Shell: Lace, hand and weight approved on a physical swatch - imported cloth rarely matches a screen.
• Length: Long, with the finished length and the hem allowance stated in centimetres, measured on the wearer, not on the form.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: name the exact tone and send a swatch. In this category a photo is not a colour reference.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Lace is judged on the ground rather than the pattern: corded lace holds a bodice, soft French lace drapes, and the scalloped edge dictates where the hem can actually finish.

A sheath backless dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Beading is quoted per panel and bought per gram. A 15% allowance sounds generous until the third size run lands.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Options We Can Build To

• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.