Long Brocade Turkish Arabic Evening Dress Style with Satin Accents

موديل فستان سهرة طويلة بروكار تركية translates roughly to "style long brocade turkish evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production this is a long brocade evening dress in the turkish direction. A long evening dress runs to the ankle or the floor, which makes sweep and hem finish the design. A floor-length hem needs a horsehair or a weighted tape, or it will collapse in wear. Brocade carries its pattern in the weave, so the motif repeat - not a print repeat - has to be planned across the bodice and the skirt panels. A ball gown carries a boned bodice and a skirt built from layers: tulle or organza over a crinoline, with the volume set by the number of layers rather than by the fabric weight.

Turkish evening wear is a fitted bodice with a very full skirt, usually in tulle or taffeta, and it is the reference most often sent to us with a photo of a bridal salon window.

What Has To Be Specified

• Shell: Brocade, hand and weight approved on a physical swatch - imported evening cloth rarely matches a screen.
• Length: Long, with the finished length and the hem allowance stated in centimetres, measured on the wearer, not on the form.
• Block: Ball Gown bodice, fitted on a real model at the middle size before grading.
• Colour: name the exact tone and send a swatch. In this category a photo is not a colour reference.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Brocade carries its pattern in the weave, so the motif repeat - not a print repeat - has to be planned across the bodice and the skirt panels.

A ball gown carries a boned bodice and a skirt built from layers: tulle or organza over a crinoline, with the volume set by the number of layers rather than by the fabric weight.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

Beading is quoted per panel and bought per gram. A 15% allowance sounds generous until the third size run lands.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.