Midi Velvet Turkish Arabic Evening Dress Style

When a request arrives with موديل فستان سهرة ميدي مخمل تركية in it, the useful first question is not the price. It is which of these attributes the buyer actually intends to sell on.

In production this is a midi velvet evening dress in the turkish direction. A midi evening dress finishes between the knee and the ankle, and it is the length that travels best: it works for a banquet, an engagement party and a wedding guest slot without a second order. Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board. A ball gown carries a boned bodice and a skirt built from layers: tulle or organza over a crinoline, with the volume set by the number of layers rather than by the fabric weight.

Turkish evening wear is a fitted bodice with a very full skirt, usually in tulle or taffeta, and it is the reference most often sent to us with a photo of a bridal salon window.

What Has To Be Specified

• Shell: Velvet, hand and weight approved on a physical swatch - imported evening cloth rarely matches a screen.
• Length: Midi, with the finished length and the hem allowance stated in centimetres, measured on the wearer, not on the form.
• Block: Ball Gown bodice, fitted on a real model at the middle size before grading.
• Colour: name the exact tone and send a swatch. In this category a photo is not a colour reference.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board.

A ball gown carries a boned bodice and a skirt built from layers: tulle or organza over a crinoline, with the volume set by the number of layers rather than by the fabric weight.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Options We Can Build To

• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Packing: flat-fold with tissue, hanger-ready, or individual sealed bag for glitter and bead styles.
• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.