Short Satin Arabic Evening Dress in Olive or Emerald - Wholesale

فستان سهرة قصيرة لون اخضر زيتي translates roughly to "short satin evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production this is a short satin evening dress, cut in olive. A short evening dress finishes above the knee and lives or dies on the hem: a 2 cm difference changes the proportion at the leg completely, and that hem is photographed more than any other part of the garment. Satin shows every needle mark and every bubble at the seam. Use a fine needle, a soft press cloth, and hang the dress for 24 hours before the final measurement. A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Olive photographs darker than it reads in the hand. Light it properly before you approve the beading colour.

What Has To Be Specified

• Shell: Satin, hand and weight approved on a physical swatch - imported evening cloth rarely matches a screen.
• Length: Short, with the finished length and the hem allowance stated in centimetres, measured on the wearer, not on the form.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: Olive, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Satin shows every needle mark and every bubble at the seam. Use a fine needle, a soft press cloth, and hang the dress for 24 hours before the final measurement.

A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Options We Can Build To

• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.