Velvet Arabic Evening Dresses in Olive or Emerald - Sample Order

فساتين سهرة قطيفة اخضر زيتي translates roughly to "velvet evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production these are velvet evening dresses, cut in olive. Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board. A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Olive photographs darker than it reads in the hand. Light it properly before you approve the beading colour.

What Has To Be Specified

• Shell: Velvet, hand and weight approved on a physical swatch - imported evening cloth rarely matches a screen.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: Olive, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Velvet has a nap. Mark every panel and never mix directions, or the dress photographs two-tone - and it can only be pressed on a velvet board.

A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Options We Can Build To

• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.