Sheath Royal Arabic Evening Dresses in Emerald - Wholesale

فساتين السهرة صك اخضر ملكي translates roughly to "royal evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production these are evening dresses in the royal direction, cut in emerald. A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

A royal direction means the dress carries its decoration centrally - a jeweled bodice, a defined waist and a skirt with controlled volume, nothing asymmetric. Emerald and deep green are the colours most likely to shift under LED lighting, so approve the dip under the light the customer will actually stand in.

What Has To Be Specified

• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: Emerald, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Options We Can Build To

• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Closure: invisible zip, exposed zip, corset lace-up or button placket, each with its own sample requirement.
• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.