Collection of Long Arabic Evening Dresses in Navy or Blue for Petite and Slim

تشكيلة فساتين سهرة للنحيفات كحلي طويلة translates roughly to "collection long evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production these are long evening dresses, cut in navy. A long evening dress runs to the ankle or the floor, which makes sweep and hem finish the design. A floor-length hem needs a horsehair or a weighted tape, or it will collapse in wear. A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Navy is the workhorse of the category: it flatters, it photographs cleanly, and it hides a slightly uneven beading density better than black.

Petite is a proportion change: the bust point, the waist and the knee line all move up, and the skirt sweep has to be rebalanced so it does not look cut short.

What Has To Be Specified

• Length: Long, with the finished length and the hem allowance stated in centimetres, measured on the wearer, not on the form.
• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Colour: Navy, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Beading is quoted per panel and bought per gram. A 15% allowance sounds generous until the third size run lands.

Pressing decides the finish. Satin and taffeta take a needle mark in a second, and no amount of QC takes it out afterwards.

Options We Can Build To

• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.