Arabic Evening Dresses with Pleats

فساتين السهرة بليسيه لون احمر translates roughly to "evening dress". In production terms it is a set of decisions rather than a single garment, which is exactly why it is worth specifying properly before the sample is cut.

In production these are pleated evening dresses, cut in red. A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Knife pleats have to be set with heat and stitched down before packing, or they arrive as soft folds and the skirt loses its sweep. Red is the highest-risk dye in the range: it crocks, it bleeds in cleaning, and it varies by lot. Fix the dip and stick to one dyehouse.

What Has To Be Specified

• Block: Sheath bodice, fitted on a real model at the middle size before grading.
• Detail: Pleated. Knife pleats have to be set with heat and stitched down before packing, or they arrive as soft folds and the skirt loses its sweep.
• Colour: Red, with a lab dip approved against a physical swatch under both D65 and warm indoor light.
• Bodice structure: say whether the bodice is boned, fused, or soft. This single line decides the fit, the price and the packing.
• Lining: state bodice lining, skirt lining and whether the skirt is bagged out at the hem.
• Closure: name the type and position - invisible zip, lace-up back, or covered button placket.
• Sizing: give the size run, the grade rule and the fit model. A Gulf 2XL is not a European 2XL.
• Care: dry-clean-only is normal here; if the trim cannot survive solvent, say so before the label is printed.

Suggested Starting Specification

Where This Style Goes Wrong In Production

A sheath evening dress is straight and close, with a walking vent at the back and a lining that has to be cut a few millimetres shorter than the shell so it does not hang below the hem.

Knife pleats have to be set with heat and stitched down before packing, or they arrive as soft folds and the skirt loses its sweep.

Beading is quoted per panel and bought per gram. A 15% allowance sounds generous until the third size run lands.

The first sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before approving anything.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Detail alternatives on the Pleated: scaled up, reduced to a plain panel, or moved to the back for a cleaner front.
• Lining: unlined bodice with a lined skirt, half-lined, or fully lined - the last one changes the hand and the cost together.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.
• Beading: hand-applied, machine-guided, or replaced with embroidery at a lower density and a lower price.

Pre-production sample approval, in-line inspection during cutting, beading and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.