Women's Tall Ladies Metallic Bronze African Two-Piece Set with Headwrap

Most requests we quote against “women's tall ladies metallic bronze african two piece set with headwrap” arrive with a photo, a target price and very little else. The photo is the easy part; the specification is where the money is saved or lost.

In practical terms this is a two-piece set in metallic wax built for women. Metallic wax carries a foil-like surface on a wax-print base. The metallic layer is the fragile part: it creases white at a hard fold and it cannot be pressed directly with a hot iron. A two-piece set is bought as one look and worn as two garments, so both pieces have to stand alone. Matching the print across the join is the first decision, not the last.

The size run is the first commercial decision: a four-size run sells a test order, a ten-size run sells a container.

What Has To Be Specified

• Shell: metallic wax, weight and hand approved on a physical swatch, not on a screen.
• Block: two-piece set, fitted on a real model at the middle size before grading.
• Detail: a matching headwrap. The headwrap is cut from the same lot as the garment and finished on all four edges; if it is a separate SKU it still has to be photographed with the dress.
• Colour: bronze, with a lab dip approved against your own colour card and a light-box check (D65 and TL84).
• Lining: state unlined, half-lined or fully lined. This single line changes the hand, the packing and the cost.
• Closure: name the type and the position. “Back zip” is not a specification; “invisible zip, CB, 55 cm, self-fabric guard” is.
• Sizing: give the size run, the grade rule and the target fit model. A four-size test and a ten-size container run are two different projects.
• Trim and hardware: bead, cord, eyelet or feather, with a colour reference and a pull-strength requirement for anything on a children's style.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Metallic wax carries a foil-like surface on a wax-print base. The metallic layer is the fragile part: it creases white at a hard fold and it cannot be pressed directly with a hot iron.

The headwrap is cut from the same lot as the garment and finished on all four edges; if it is a separate SKU it still has to be photographed with the dress.

A two-piece set is bought as one look and worn as two garments, so both pieces have to stand alone. Matching the print across the join is the first decision, not the last.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

The first sample usually passes on the mannequin and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before you approve anything.

Options We Can Build To

• Closure: invisible zip, exposed zip, button placket or lace-up, each with its own sample requirement.
• Detail variations on the a matching headwrap: scaled up, scaled down, or replaced with a plain panel at a lower price point.
• Closure: invisible zip, exposed zip, button placket or lace-up, each with its own sample requirement.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Trim: embroidered, beaded or plain, with the density quoted per panel rather than per garment.

Pre-production sample approval, in-line inspection during cutting and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.