Bride and Groom African Kimono Jacket with High-Slit

Most requests we quote against “bride and groom african kimono jacket with high slit” arrive with a photo, a target price and very little else. The photo is the easy part; the specification is where the money is saved or lost.

In practical terms this is a kimono jacket in ankara wax print built for brides and grooms. Ankara is a wax-printed cotton, normally 100-120 gsm. The hand is slightly crisp, so it holds a peplum, a pleat or a stand collar without much interlining, and it presses flat after a hot iron. A kimono jacket is an open, drop-shoulder layer with a wide sleeve. It is the easiest entry point into the category for a buyer testing a print, because it needs no fitting.

Bridal and groom sets are ordered months ahead and fitted twice, so the sampling calendar, not the price, is usually the constraint.

What Has To Be Specified

• Shell: ankara wax print, weight and hand approved on a physical swatch, not on a screen.
• Block: kimono jacket, fitted on a real model at the middle size before grading.
• Detail: a high front slit. A high front slit needs a facing or a bound edge, and it needs the slit stop reinforced — that is where every one of these returns begins.
• Colour: name the colourway and give a reference swatch. “African print” is not a colour; a lab dip checked under D65 and TL84 is.
• Lining: state unlined, half-lined or fully lined. This single line changes the hand, the packing and the cost.
• Closure: name the type and the position. “Back zip” is not a specification; “invisible zip, CB, 55 cm, self-fabric guard” is.
• Sizing: give the size run, the grade rule and the target fit model. A four-size test and a ten-size container run are two different projects.
• Trim and hardware: bead, cord, eyelet or feather, with a colour reference and a pull-strength requirement for anything on a children's style.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Ankara is a wax-printed cotton, normally 100-120 gsm. The hand is slightly crisp, so it holds a peplum, a pleat or a stand collar without much interlining, and it presses flat after a hot iron.

A high front slit needs a facing or a bound edge, and it needs the slit stop reinforced — that is where every one of these returns begins.

A kimono jacket is an open, drop-shoulder layer with a wide sleeve. It is the easiest entry point into the category for a buyer testing a print, because it needs no fitting.

The hem is where a cheap build shows. A 3 cm hem with a clean catch-stitch reads expensive; a 1 cm overlocked hem reads fast fashion.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Options We Can Build To

• Closure: invisible zip, exposed zip, button placket or lace-up, each with its own sample requirement.
• Detail variations on the a high front slit: scaled up, scaled down, or replaced with a plain panel at a lower price point.
• Trim: embroidered, beaded or plain, with the density quoted per panel rather than per garment.
• Packing: flat-fold with tissue, hanger-ready, or individual polybag with a branded insert.
• Packing: flat-fold with tissue, hanger-ready, or individual polybag with a branded insert.

Pre-production sample approval, in-line inspection during cutting and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.