Women's African Gala Banquet African Agbada Suit

The phrase “women's african gala banquet african agbada suit” reads like a styling note and behaves like a spec sheet. Once you unpack it, it names a cloth, a cut and a wearer - and those three decisions fix roughly eighty per cent of the cost before a single sample is cut.

In practical terms this is a agbada suit in ankara wax print built for women. Ankara is a wax-printed cotton, normally 100-120 gsm. The hand is slightly crisp, so it holds a peplum, a pleat or a stand collar without much interlining, and it presses flat after a hot iron. An agbada suit is a three-piece: the flowing outer robe, a shorter under-tunic, and straight trousers. The robe carries the drama, the tunic carries the fit, and the trousers have to be cut to the same drop as the robe hem.

The size run is the first commercial decision: a four-size run sells a test order, a ten-size run sells a container.

What Has To Be Specified

• Shell: ankara wax print, weight and hand approved on a physical swatch, not on a screen.
• Block: agbada suit, fitted on a real model at the middle size before grading.
• Colour: name the colourway and give a reference swatch. “African print” is not a colour; a lab dip checked under D65 and TL84 is.
• Lining: state unlined, half-lined or fully lined. This single line changes the hand, the packing and the cost.
• Closure: name the type and the position. “Back zip” is not a specification; “invisible zip, CB, 55 cm, self-fabric guard” is.
• Sizing: give the size run, the grade rule and the target fit model. A four-size test and a ten-size container run are two different projects.
• Trim and hardware: bead, cord, eyelet or feather, with a colour reference and a pull-strength requirement for anything on a children's style.

Suggested Starting Specification

Where This Style Goes Wrong In Production

Ankara is a wax-printed cotton, normally 100-120 gsm. The hand is slightly crisp, so it holds a peplum, a pleat or a stand collar without much interlining, and it presses flat after a hot iron.

An agbada suit is a three-piece: the flowing outer robe, a shorter under-tunic, and straight trousers. The robe carries the drama, the tunic carries the fit, and the trousers have to be cut to the same drop as the robe hem.

The first sample usually passes on the mannequin and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before you approve anything.

The first sample usually passes on the mannequin and fails on a body: the waist sits high, the armhole cuts, or the sweep is 4 cm short. Fit on a real model before you approve anything.

Two rolls of the same colour name will not match. Buy one lot, keep a roll reference with the order, and cut the whole run from it.

Options We Can Build To

• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Sizing: a four-size test run, a standard eight-size run, or a graded run to your own spec sheet.
• Shell swap: the same block in a lighter or heavier version of the base cloth, priced separately.
• Closure: invisible zip, exposed zip, button placket or lace-up, each with its own sample requirement.

Pre-production sample approval, in-line inspection during cutting and sewing, and a final AQL inspection before packing, with measurement reports and photos shared before shipment.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.