Welcome to Bafinasa official website!

Casual Summer 2026 Polyester Chiffon Camisole

Source:News / Time:2026-11-19

There is nothing experimental about this garment. The difficulty is discipline: the same four measurements decide fit on every size, and they have to be printed, not remembered. Written down, the request is casual summer 2026 polyester chiffon camisole: a body, a length and a budget. Those three lines are enough to start a pattern, provided somebody writes the fourth line - the finish. A Casual Summer 2026 Polyester Chiffon Camisole reads as a short brief until the pattern is cut, and the shape only holds when the collar, the placket and the hem allowance are settled together. The first conversation about this style is usually about length. The second, if the buyer is serious, is about the inside: lining, interlining, and where the seams are pressed.

Keep one dye lot for bulk. Splitting a thousand pieces across two lots is how a reorder ends up with a visible line between sizes. Cloth decides more than the brief admits. The same block in a 180 gsm wool blend and a 260 gsm double knit produces two different garments, one for the office and one for the evening. Under 200 gsm, plan to interface the collar. Without it, the seam ridge shows through at the first press. The hand a buyer approves on a swatch is what bulk has to repeat. If the mill cannot repeat it, change the mill before the pattern is graded.

How it is built

Most of the handwork sits in a handful of steps, and each one has a right order. On light cloth, ease the sleeve head rather than gathering it. The sleeve should hold shape without puckers. Cuffs are cut in pairs from the same panel. A mismatched pair is the first thing an inspector sees.

When the brief names the collar, allow extra cloth and extra time: it is cut from a separate panel and has to be matched for grain. If the collar is central to the style, price a second sample with a simpler version. Volume often goes to the simpler one.

Tolerances belong on the sheet: plus or minus one centimetre on the body, half a centimetre on the collar. On this style the difference between a good and a poor fit is usually two centimetres at the placket, not a redesign. A size run that stops at XL will not sell where the middle size is a Large. State the run and the grade rule at quoting, not at shipping.

What goes on the spec sheet

Shellchiffon, swatch-approved, one dye lot for bulk
Bodyblouse
Lengthconfirmed on the wearer, in her shoes
Colourwaybuyer colourway, lab-dipped under two lights
Liningno lining; faced yoke, cuffs and placket
Closurecovered button placket
Size runXS-2XL plus a curve block
Sample lead time10-14 days on stock cloth
MOQ100 pcs per colour

Where this style fails in production

  • Collar fused too hard, giving a plastic edge that cannot be pressed into shape.
  • Buttons sized to the sample rather than to the placket, so bulk splits the button stand.
  • Sleeve gathered rather than eased, producing puckers that show on a plain cloth.
  • The sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is short. Fit on a real model before approving anything.
  • Two rolls under the same colour name will not match. Buy one lot, keep the roll reference with the order, and cut the run from it.

Keep one sealed bulk sample per colour. Six months later it is the only honest reference for a reorder. Pressing is a step, not a rescue. A seam pressed open before the next one is sewn behaves differently from one pressed at the end. Measure ten pieces per size from the first bulk run. If the spread is wider than the tolerance, the cutting and not the sewing is the problem.

Customisation that does not break the price

  • Cuff: buttoned, elasticated, or turned back.
  • Back: plain, box pleat, or yoke with a loop.
  • Sizing: a four-size test run, a standard eight-size run, or a graded run to your own sheet.
  • Private label: woven label, care label and hangtag to your artwork.

The pre-production sample has to be cut from the bulk lot, with the bulk trims, on the machine settings bulk will use. Keep the approved pre-production sample sealed. It is the reference for the in-line check and for the reorder. The proto is usually made in stock cloth. Do not judge the hand from it; judge the line.

A reorder is easier than a first order, provided the approved sample and the measurement sheet were kept together. Ask for two samples when the cloth is new to us: one in the buyer cloth, one in our closest stock cloth. The comparison usually settles the price question.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.

Online customer service
WeChat contact
Customer service
Scan code to add Wechat (same mobile phone number)
Telephone consultation
Back to top