Welcome to Bafinasa official website!

For Women Burgundy Tiered Casual Dresses

Source:News / Time:2026-11-19

Samples for this garment rarely fail on design. They fail on a measurement that was never written down, and a cloth that behaved differently from the swatch. Nothing in this style is hard to sew. It is hard to sew consistently, which is a different problem and a more expensive one. The first conversation about this style is usually about length. The second, if the buyer is serious, is about the inside: lining, interlining, and where the seams are pressed. A For Women Burgundy Tiered Casual Dresses can be made at almost any price. What changes is how long it keeps its line and how much of the making shows.

We start with cotton jersey or washed poplin on the first sample and keep one alternative on the table, then compare how each hangs on a moving model rather than on the form. Ask for weight in gsm and composition as percentages, not trade names. Trade names do not travel well between mills. Cloth decides more than the brief admits. The same block in a 180 gsm wool blend and a 260 gsm double knit produces two different garments, one for the office and one for the evening. Wash the sample once before approval. Some cloths lose two centimetres of length and gain a surface that was not on the swatch.

How it is built

The pattern sets the shape and the sewing protects it. A few steps decide whether it survives the third wash. Stitch with a stretch needle and a light press. A heavy hand leaves waves that show on a plain colour. Jersey is cut in a single layer in the direction of the grain. Two layers can shift and twist the hem. A casual dress has to survive a washing machine. Confirm shrinkage on the actual lot before the pattern is final.

Check the tiered after pressing, not before. Light cloth relaxes under steam and what looked balanced on the table can shift. The tiered reads as a design choice and behaves as a construction one. It changes the seam order, and sometimes the closure.

We fit the middle size on a live model, then check the smallest and the largest on real bodies, not on the form. On this style the difference between a good and a poor fit is usually two centimetres at the side seam, not a redesign. Get the fit model measurements in the same units as the spec. Mixed units are the most common cause of a rejected first sample.

Spec sheet, line by line

Shella 160 to 220 gsm cotton jersey or a washed poplin, swatch-approved, one dye lot for bulk
Bodycasual dress
Lengthconfirmed on the wearer, in her shoes
Colourwayburgundy
Liningunlined with faced seams
Closureconcealed side zip
Size runXS-2XL plus a curve block
Sample lead time15-20 days with handwork
MOQ150 pcs per style

Failure points worth designing out

  • Shrinkage tested on a different dye lot, so the first wash shortens the dress.
  • Jersey cut in two layers, giving a hem that twists after washing.
  • Pocket bags cut too short, so they pull the skirt out at the hip.
  • Pressing decides the finish. A needle mark on a light cloth stays after QC, whatever the inspector does.
  • Every detail placed by eye on the sample has to be measured on the pattern, or the size run drifts.

Trims are ordered against confirmed quantity plus three percent. Short trims stop a line faster than short cloth. Keep one sealed bulk sample per colour. Six months later it is the only honest reference for a reorder. AQL 2.5 on major and 4.0 on minor is a reasonable default here. Write it into the order so the inspection has a rule.

Options on the table

  • Length: above the knee, at the knee, or midi.
  • Pockets: none, side seam, or patch.
  • Print placement or solid with a contrast binding.
  • Sleeve: short, cap, or long with a rib cuff.
  • Sizing: a four-size test run, a standard eight-size run, or a graded run to your own sheet.
  • Private label: woven label, care label and hangtag to your artwork.

Keep the approved pre-production sample sealed. It is the reference for the in-line check and for the reorder. The pre-production sample has to be cut from the bulk lot, with the bulk trims, on the machine settings bulk will use. The proto is usually made in stock cloth. Do not judge the hand from it; judge the line.

Confirm the ship window against the mill calendar and the holiday shutdown before the purchase order is signed. A sample order of fifty to a hundred pieces is enough to test the pattern, the cloth and the trims before a season is committed.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.

Online customer service
WeChat contact
Customer service
Scan code to add Wechat (same mobile phone number)
Telephone consultation
Back to top