Welcome to Bafinasa official website!

Burgundy Off Shoulder Cocktail Midi Dress for Women

Source:News / Time:2026-11-19

The first conversation about this style is usually about length. The second, if the buyer is serious, is about the inside: lining, interlining, and where the seams are pressed. There is nothing experimental about this garment. The difficulty is discipline: the same four measurements decide fit on every size, and they have to be printed, not remembered. Written down, the request is burgundy off shoulder cocktail midi dress for women: a body, a length and a budget. Those three lines are enough to start a pattern, provided somebody writes the fourth line - the finish. A Burgundy Off Shoulder Cocktail Midi Dress for Women reads as a short brief until the pattern is cut, and the shape only holds when the bodice seam, the waist seam and the hem allowance are settled together.

Keep one dye lot for bulk. Splitting a thousand pieces across two lots is how a reorder ends up with a visible line between sizes. Wash the sample once before approval. Some cloths lose two centimetres of length and gain a surface that was not on the swatch. We start with structured crepe, jacquard or satin on the first sample and keep one alternative on the table, then compare how each hangs on a moving model rather than on the form. Request a shrink test on the actual dye lot. Half a percent across a midi is visible to the customer and invisible on the sheet.

How it is built

Most of the handwork sits in a handful of steps, and each one has a right order. The zip is set at the back with a facing that stays flat, and the seam is tapered so it does not widen at the hip. A cocktail dress is cut close enough that seam allowances have to be pressed before they are joined. Otherwise the line shows through the cloth. The bodice is fitted at the middle size with real underwear, then graded without adding ease at the bust.

When the brief names the off shoulder, allow extra cloth and extra time: it is cut from a separate panel and has to be matched for grain. If the off shoulder is central to the style, price a second sample with a simpler version. Volume often goes to the simpler one.

Shoulder and neckline decide whether a Burgundy Off Shoulder Cocktail Midi Dress for Women looks expensive. Both are set by the block, not by the sewing. Grading is where the quiet failures happen. Four sizes from one block need the armhole, the waist and the bodice seam to move at different rates. A size run that stops at XL will not sell where the middle size is a Large. State the run and the grade rule at quoting, not at shipping.

The sheet we need before costing

Shella structured crepe, a jacquard, or a satin backed with soft interfacing, swatch-approved, one dye lot for bulk
Bodycocktail midi dress
Lengthmidi
Colourwayburgundy
Liningfully lined, bagged hem
Closureinvisible centre-back zip
Size run34-44 with a regional grade
Sample lead time12-18 days after spec sign-off
MOQ100 pcs per colour

What to check before bulk

  • Back hem one centimetre shorter than the front, visible as soon as the wearer walks.
  • Topstitch showing through a satin shell after pressing.
  • Every detail placed by eye on the sample has to be measured on the pattern, or the size run drifts.
  • Pressing decides the finish. A needle mark on a light cloth stays after QC, whatever the inspector does.

Pressing is a step, not a rescue. A seam pressed open before the next one is sewn behaves differently from one pressed at the end. Lead time is normally 12 to 20 days for a first sample and 30 to 45 days for bulk, depending on stock cloth and handwork.

Customisation that does not break the price

  • Back: centre zip, lace-up, or a covered button placket.
  • Sleeve: sleeveless, cap, or detachable straps.
  • Neckline: square, V, or one shoulder with a faced edge.
  • Decoration: none, tonal embroidery, or a beaded motif at the waist.
  • Private label: woven label, care label and hangtag to your artwork.
  • Sizing: a four-size test run, a standard eight-size run, or a graded run to your own sheet.

Sampling runs in three steps: a proto to check proportion, a fit sample to check the body, and a pre-production sample cut from bulk cloth. The proto is usually made in stock cloth. Do not judge the hand from it; judge the line. The fit sample is where the pattern is corrected. Changes after this point cost time, not only money.

Ask for two samples when the cloth is new to us: one in the buyer cloth, one in our closest stock cloth. The comparison usually settles the price question. A sample order of fifty to a hundred pieces is enough to test the pattern, the cloth and the trims before a season is committed.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.

Online customer service
WeChat contact
Customer service
Scan code to add Wechat (same mobile phone number)
Telephone consultation
Back to top