For Women Burgundy Maxi Casual Dresses
Written down, the request is for women burgundy maxi casual dresses: a body, a length and a budget. Those three lines are enough to start a pattern, provided somebody writes the fourth line - the finish. The first conversation about this style is usually about length. The second, if the buyer is serious, is about the inside: lining, interlining, and where the seams are pressed.
Request a shrink test on the actual dye lot. Half a percent across a maxi is visible to the customer and invisible on the sheet. We start with viscose crepe or cotton blend on the first sample and keep one alternative on the table, then compare how each hangs on a moving model rather than on the form. Wash the sample once before approval. Some cloths lose two centimetres of length and gain a surface that was not on the swatch. Keep one dye lot for bulk. Splitting a thousand pieces across two lots is how a reorder ends up with a visible line between sizes.
Construction notes
Most of the handwork sits in a handful of steps, and each one has a right order. A maxi is a length decision before it is a style decision. Confirm the finished length on the wearer, in her shoes. Slits are faced and bar-tacked at the top. An unbar-tacked slit opens within a week. For lined skirts, bag the hem or face it, and say which. The two finishes behave differently in packing.
The hem reads as a design choice and behaves as a construction one. It changes the seam order, and sometimes the closure. If the hem is central to the style, price a second sample with a simpler version. Volume often goes to the simpler one.
If the buyer sells online, photograph the size chart on real bodies. That reduces returns more than any pattern change we can make. Grading is where the quiet failures happen. Four sizes from one block need the armhole, the waist and the waist seam to move at different rates. On this style the difference between a good and a poor fit is usually two centimetres at the side seam, not a redesign.
What goes on the spec sheet
| Shell | a viscose crepe or a 110 gsm cotton blend with some weight, swatch-approved, one dye lot for bulk |
| Body | maxi dress |
| Length | maxi |
| Colourway | burgundy |
| Lining | unlined with faced seams |
| Closure | invisible centre-back zip |
| Size run | S-3XL graded to your sheet |
| Sample lead time | 15-20 days with handwork |
| MOQ | 100 pcs per colour |
What to check before bulk
- Length measured on the form, so bulk is short on a real body.
- Waist seam un-interfaced, so the skirt drags it down at the centre front.
- Hem pressed with too much steam, leaving a wavy edge that cannot be corrected.
- Two rolls under the same colour name will not match. Buy one lot, keep the roll reference with the order, and cut the run from it.
- The sample passes on the form and fails on a body: the waist sits high, the armhole cuts, or the sweep is short. Fit on a real model before approving anything.
Packing flat or on hangers changes the crease pattern. Decide before the cartons are ordered. Set stitch density at 12 to 14 per inch on woven seams and check it at the machine, not on the finished garment. Measure ten pieces per size from the first bulk run. If the spread is wider than the tolerance, the cutting and not the sewing is the problem.
What we can change for you
- Waist: fixed, elasticated, or drawstring.
- Lining: full, half, or none.
- Packing: flat-fold with tissue, hanger-ready, or a sealed bag per piece.
- Private label: woven label, care label and hangtag to your artwork.
Keep the approved pre-production sample sealed. It is the reference for the in-line check and for the reorder. Sampling runs in three steps: a proto to check proportion, a fit sample to check the body, and a pre-production sample cut from bulk cloth. The proto is usually made in stock cloth. Do not judge the hand from it; judge the line.
A reorder is easier than a first order, provided the approved sample and the measurement sheet were kept together. Send the tech pack as a PDF with a measurement table, not as a photo with notes in a chat. Photos carry intent, tables carry production.
If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.