Wholesale Red High Slit Bodycon Dress

It helps to separate what the customer sees from what the factory feels. The outside is bandage knit or heavy ponte in red, the inside is structure, and the two have to agree on the same sample. Buyers arrive with a reference photo and a target price. The two numbers that decide whether that price is reachable are the cloth weight and how many seams run through the side panel.

Stretch is the quiet variable. Two percent elastane changes the grade rule, the seam type, and how the hem behaves after ten washes. For bandage knit or heavy ponte, order five to eight percent extra. Cutting around a shade band costs more than the cloth. Request a shrink test on the actual dye lot. Half a percent across a long hem is visible to the customer and invisible on the sheet. Cloth decides more than the brief admits. The same block in a 180 gsm wool blend and a 260 gsm double knit produces two different garments, one for the office and one for the evening.

Construction notes

Most of the handwork sits in a handful of steps, and each one has a right order. Join with a stretch stitch and press the seams open. A straight stitch pops the first time the wearer sits down. Zip placement decides how the dress goes on. A centre-back zip is neat; a side zip is easier to wear and harder to hide. The hem is the hard part. A twin needle or a coverstitch keeps it flat; a plain hem waves.

If the neckline is central to the style, price a second sample with a simpler version. Volume often goes to the simpler one. The neckline reads as a design choice and behaves as a construction one. It changes the seam order, and sometimes the closure.

We fit the middle size on a live model, then check the smallest and the largest on real bodies, not on the form. On this style the difference between a good and a poor fit is usually two centimetres at the centre front seam, not a redesign. Get the fit model measurements in the same units as the spec. Mixed units are the most common cause of a rejected first sample.

The sheet we need before costing

Failure points worth designing out

• Cloth with insufficient recovery, so the dress grows through the day.
• A standard stitch instead of a stretch stitch, giving popped seams after the first wear.
• Too few panels, so the garment pulls across the hip and the seam line distorts.
• Pressing decides the finish. A needle mark on a light cloth stays after QC, whatever the inspector does.
• Pressing decides the finish. A needle mark on a light cloth stays after QC, whatever the inspector does.

Lead time is normally 12 to 20 days for a first sample and 30 to 45 days for bulk, depending on stock cloth and handwork. Measure ten pieces per size from the first bulk run. If the spread is wider than the tolerance, the cutting and not the sewing is the problem. Trims are ordered against confirmed quantity plus three percent. Short trims stop a line faster than short cloth.

Options on the table

• Sleeve: sleeveless, cap, or long sleeve in the same cloth.
• Panel count from four to eight, with a small cost difference per unit.
• Packing: flat-fold with tissue, hanger-ready, or a sealed bag per piece.
• Packing: flat-fold with tissue, hanger-ready, or a sealed bag per piece.

Keep the approved pre-production sample sealed. It is the reference for the in-line check and for the reorder. Photograph each stage on the same model and keep the photos with the spec sheet. Most disputes end there. The pre-production sample has to be cut from the bulk lot, with the bulk trims, on the machine settings bulk will use.

Ask for two samples when the cloth is new to us: one in the buyer cloth, one in our closest stock cloth. The comparison usually settles the price question. Send the tech pack as a PDF with a measurement table, not as a photo with notes in a chat. Photos carry intent, tables carry production.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.