Welcome to Bafinasa official website!

Mustard Yellow Tiered Boho Maxi Dress for Women

Source:News / Time:2026-11-14

Written down, the request is mustard yellow tiered boho maxi dress for women: a body, a length and a budget. Those three lines are enough to start a pattern, provided somebody writes the fourth line - the finish. A Mustard Yellow Tiered Boho Maxi Dress for Women reads as a short brief until the pattern is cut, and the shape only holds when the tier seam, the waist seam and the hem allowance are settled together. The first conversation about this style is usually about length. The second, if the buyer is serious, is about the inside: lining, interlining, and where the seams are pressed. There is nothing experimental about this garment. The difficulty is discipline: the same four measurements decide fit on every size, and they have to be printed, not remembered.

Request a shrink test on the actual dye lot. Half a percent across a maxi is visible to the customer and invisible on the sheet. Lining is not a detail. A 65 to 75 gsm taffeta slides over the cloth; a cheap lining grabs it and the garment climbs when the wearer walks. Approve colour under two lights, D65 and warm indoor. A black that reads neutral in an office can read green under shop lighting. Keep one dye lot for bulk. Splitting a thousand pieces across two lots is how a reorder ends up with a visible line between sizes.

How it is built

Most of the handwork sits in a handful of steps, and each one has a right order. Lining a sheer maxi is a design decision, not a default. State the lining length separately or it will be made to the shell. Tiered skirts need every tier cut on the same grain and the gather ratio written down. Otherwise the volume changes between sizes. Loose weaves need a French or flat-felled seam. A plain overlock shows at the slit and at the hem.

Check the tiered after pressing, not before. Light cloth relaxes under steam and what looked balanced on the table can shift. The tiered is where the eye lands first, so it is also where a two-millimetre error shows. Set it from the pattern, not from the sample.

A size run that stops at XL will not sell where the middle size is a Large. State the run and the grade rule at quoting, not at shipping. On this style the difference between a good and a poor fit is usually two centimetres at the waist seam, not a redesign. Tolerances belong on the sheet: plus or minus one centimetre on the body, half a centimetre on the tier seam.

Specification, item by item

Shella 90 to 120 gsm cotton voile, or a viscose crinkle for movement, swatch-approved, one dye lot for bulk
Bodyboho maxi dress
Lengthmaxi
Colourwayyellow
Liningbodice lined, skirt lined
Closureinvisible centre-back zip
Size runS-XL (4 sizes) for the test
Sample lead time15-20 days with handwork
MOQ100 pcs per colour

What to check before bulk

  • Gather ratios left to the operator, so two sizes of the same tier look different.
  • Print placement ignored at the centre front, so the motif lands off-centre in bulk.
  • A cheap hem shows: three centimetres with a clean catch-stitch reads expensive, one centimetre overlocked reads fast fashion.
  • Two rolls under the same colour name will not match. Buy one lot, keep the roll reference with the order, and cut the run from it.

Measure ten pieces per size from the first bulk run. If the spread is wider than the tolerance, the cutting and not the sewing is the problem. Keep one sealed bulk sample per colour. Six months later it is the only honest reference for a reorder. Packing flat or on hangers changes the crease pattern. Decide before the cartons are ordered.

Changes we can make at sample stage

  • Tier count and depth, priced per configuration.
  • Neckline: square with ties, V with a modesty panel, or elasticated.
  • Shell swap: the same block in a lighter or heavier cloth, priced separately.
  • Sizing: a four-size test run, a standard eight-size run, or a graded run to your own sheet.

The pre-production sample has to be cut from the bulk lot, with the bulk trims, on the machine settings bulk will use. Keep the approved pre-production sample sealed. It is the reference for the in-line check and for the reorder. The proto is usually made in stock cloth. Do not judge the hand from it; judge the line.

A reorder is easier than a first order, provided the approved sample and the measurement sheet were kept together. Ask for two samples when the cloth is new to us: one in the buyer cloth, one in our closest stock cloth. The comparison usually settles the price question.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.

Online customer service
WeChat contact
Customer service
Scan code to add Wechat (same mobile phone number)
Telephone consultation
Back to top