Welcome to Bafinasa official website!

Tassel Ties Terracotta Long Sleeve Boho Maxi Dress

Source:News / Time:2026-11-14

It helps to separate what the customer sees from what the factory feels. The outside is cotton voile or viscose crinkle, the inside is structure, and the two have to agree on the same sample. Written down, the request is tassel ties terracotta long sleeve boho maxi dress: a body, a length and a budget. Those three lines are enough to start a pattern, provided somebody writes the fourth line - the finish. Samples for this garment rarely fail on design. They fail on a measurement that was never written down, and a cloth that behaved differently from the swatch.

Lining is not a detail. A 65 to 75 gsm taffeta slides over the cloth; a cheap lining grabs it and the garment climbs when the wearer walks. Request a shrink test on the actual dye lot. Half a percent across a maxi is visible to the customer and invisible on the sheet. Under 200 gsm, plan to interface the tier seam. Without it, the seam ridge shows through at the first press. Stretch is the quiet variable. Two percent elastane changes the grade rule, the seam type, and how the hem behaves after ten washes.

Construction notes

Most of the handwork sits in a handful of steps, and each one has a right order. Trims and tassels go on after the first fitting. They change the weight of the hem and how the skirt falls. Measure a maxi from the waist once the skirt is gathered, not from the shoulder on the flat. Drawstrings are threaded after washing the sample. A cotton cord that shrinks will pucker the channel.

When the brief names the long sleeve, allow extra cloth and extra time: it is cut from a separate panel and has to be matched for grain. The long sleeve is where the eye lands first, so it is also where a two-millimetre error shows. Set it from the pattern, not from the sample.

Get the fit model measurements in the same units as the spec. Mixed units are the most common cause of a rejected first sample. A size run that stops at XL will not sell where the middle size is a Large. State the run and the grade rule at quoting, not at shipping. For Boho Maxi Dresses sold across regions, keep one measurement sheet per market; one market's Large is another market's Medium.

Spec sheet, line by line

Shella 90 to 120 gsm cotton voile, or a viscose crinkle for movement, swatch-approved, one dye lot for bulk
Bodyboho maxi dress
Lengthmaxi
Colourwaybuyer colourway, lab-dipped under two lights
Lininghalf lined to the hip
Closureconcealed side zip
Size run34-44 with a regional grade
Sample lead time10-14 days on stock cloth
MOQ150 pcs per style

The places this usually goes wrong

  • Print placement ignored at the centre front, so the motif lands off-centre in bulk.
  • Gather ratios left to the operator, so two sizes of the same tier look different.
  • Two rolls under the same colour name will not match. Buy one lot, keep the roll reference with the order, and cut the run from it.
  • A cheap hem shows: three centimetres with a clean catch-stitch reads expensive, one centimetre overlocked reads fast fashion.

Keep one sealed bulk sample per colour. Six months later it is the only honest reference for a reorder. Pressing is a step, not a rescue. A seam pressed open before the next one is sewn behaves differently from one pressed at the end. Measure ten pieces per size from the first bulk run. If the spread is wider than the tolerance, the cutting and not the sewing is the problem.

Changes we can make at sample stage

  • Print: stock, custom digital, or placement-matched at the front.
  • Sleeve: blouson, flutter, or straight with a ruffle.
  • Sizing: a four-size test run, a standard eight-size run, or a graded run to your own sheet.
  • Private label: woven label, care label and hangtag to your artwork.

The fit sample is where the pattern is corrected. Changes after this point cost time, not only money. Photograph each stage on the same model and keep the photos with the spec sheet. Most disputes end there. Sampling runs in three steps: a proto to check proportion, a fit sample to check the body, and a pre-production sample cut from bulk cloth.

If the price has to come down, take it out of handwork before taking it out of the cloth. The customer notices the cloth first. A sample order of fifty to a hundred pieces is enough to test the pattern, the cloth and the trims before a season is committed.

If you are developing this style, send us a tech pack, a photo or a reference garment and we will quote within 24 hours. Contact bafinasa@bafinasa.com or WhatsApp +86 13827222469.

Online customer service
WeChat contact
Customer service
Scan code to add Wechat (same mobile phone number)
Telephone consultation
Back to top